Pure Stock Rules

BODY:
A. ANY 1948 OR NEWER SEDAN OR COUPE, MINIMUM CUTTING FOR TIRES AND AIR FILTER

B. STOCK WHEEL BASE

C. STOCK BUMPERS IN STOCK LOCATION. BUMPERS MAY BE CUT SLIGHTLY, BUT NO SHARP EDGES.

D. MUST HAVE WRECKER LOOPS ON FRONT AND REAR OF CAR

E. ALL DOORS MUST BE WELDED OR BOLTED SHUT

F. ALL GLASS MUST BE REMOVED

G. RACING SEAT WITH APPROVED SHOULDER HARNESS REQUIRED...

H. 4 POST ROLL CAGE WELDED TO THE FRAME WITH 3 OR MORE BARS IN THE DRIVER DOOR. ALL BARS MUST BE 2" OR LARGER.

J. UNIBODIES CAN BE TIED TOGETHER.

K. CAR MUST BE STRICTLY STOCK APPEARING. MINIMUM CUTTING ALLOWED FOR TIRES AND AIR FILTER

L. PLASTIC GROUND EFFECTS ARE PERMITTED

M. PEDALS MUST BE IN STOCK LOCATION

N. BATTERY MUST BE RELOCATED AND STRAPPED SECURELY IN BATTERY BOX IN COCKPIT

ENGINE:
A. 362 CU. INCH, 3300 lbs. Big Blocks 3650 lbs NO 400 BLOCKS

B. MUST PULL 16" VACUUM AT 900 RPM BY TRACK GAUGE 

C. ANY FLAT TOP OR DISH PISTONS ALLOWED NOT TO EXCEED DECK HEIGHT.

D. STOCK RODS, CRANK, HEADS, ROCKER ARMS, CARB, IGNITION, AND BLOCK FROM THE MANUFACTURER.

E. NO VORTEC HEADS ALLOWED

F. NO PORTING AND POLISHING AT ALL

G. STOCK FLYWHEEL 10.5 inch Minimum, PRESSURE PLATE, AND CLUTCH OR TORQUE CONVERTER

H. CAM MAXIMUM LIFT "480 WITH .010" TOLERANCE. CAM WILL BE CHECKED AT THE VALVE.

I. .005 FEELER GAUGE WILL BE USED TO CHECK FOR SOLID LIFT CAMS

J. INTAKE MUST HAVE STOCK CASTING. NO ALUMINUM INTAKES OR HIGH RISES. NO MARINE INTAKES OR SPACERS.

K. BIGGER VALVES AND SPRINGS MAY BE INSTALLED

L. NO SOLID LIFT OR ROLLER CAMS OR LIFTERS

M. STOCK FUEL PUMP IN STOCK LOCATION ONLY

N. SCREW IN STUDS AND GUIDE PLATES ARE ALLOWED

O. CARBURETOR: Quadra jet or 600 Holley Vacuum Secondary Choke Horns Must remain

P. NO ALUMINUM HEADS OR BOWTIE BLOCKS ALLOWED

Q. CAN HAVE AFTER MARKET PULLEYS

R. ENGINE MUST BE IN STOCK LOCATION

TIRES AND WHEELS:
A. NO RACING TIRES

B. 8 " STEEL WHEELS PERMITTED

C. NO RACING RECAPS

D. BEADLOCKS ALLOWED RIGHT REAR ONLY

E. CAN RUN 60 SERIES TIRES NO WIDER THAN 10"

SUSPENSION:
A. SHOCKS AND SPRINGS MUST STAY IN STOCK LOCATION

B. RACING SPRINGS AND SHOCKS PERMITTED. WEIGHT JACKS ALLOWED ON REAR ONLY

C. WHEELS MAY BE REINFORCED TO PREVENT LOSS. PLATING, WASHERS, OR DOUBLE NUTS RECOMMENDED

D. 9" FORD REAR END PERMITTED. NO QUICK CHANGE OR 3/4 TON REAR ENDS ALLOWED.

E. NO QUICK STEERS ALLOWED

F. STOCK STEERING BOX AND POWER STEERING
PUMP FOR THAT MAKE OF CAR

G. Competition Rule: Feature winners will start no higher than row three on next appearance at track. Two consecutive wins and you will start no higher than row 5 on next appearance at track. Three consecutive wins and you will start on last row of next feature. Any Racer that wins 4 features will start no better than row three in feature the remainder of the season.

Protests:
A. Any and all protests must be made within 10 minutes of the feature race.

B. You must finish in the top 3 of the feature to make a protest.

Protest Fees:

A. Valve Cover $50 - $25 to track 
B. Top Half (1 Head) $250 - $50 to track

C. Whole Engine (1 Head and Oil Pan) $500 - $100 to track